Linear (1D) optimizer
Lumber, trim, pipe and profiles: lengths, miters, rip cuts and paint.
- Add stock lengthsSet up the boards, bars or pipe you're cutting from, including mixed lengths like 8′, 10′ and 12′.Available onFree toolsProBusinessTeam
- Enter linear partsAdd cut lengths, set quantities, assign stock, and use Repeat list for repeated assemblies.Available onFree toolsProBusinessTeam
- Miter endsAdd miter angles to each end of a piece for frames, trim and casing.Available onProBusinessTeamBeta
- Cross-section (rip) cutsRip a wide timber into several smaller sticks before cross-cutting to length.Available onProBusinessTeamBeta
- Paint estimateEstimate how much primer, paint or finish your linear parts need.Available onProBusinessTeamBeta
- Linear nesting methodsLeast waste vs Batch cutting: fewest boards, or fewest stop-block changes.Available onFree toolsProBusinessTeam
- Read linear resultsPieces, yield, waste, cost and the cut diagram for each bar.Available onFree toolsProBusinessTeam